Husqvarna Automower EPOS Plug-in Kit Bedienungsanweisung Seite 111

A
• For slopes adjacent to a public road, put a fence or
a protective wall along the outer edge of the slope.
39.10 To install the product
1. Install the EPOS ™ Plug-in. Refer to
EPOS plug-in on page 111 .
®
2. Install the Automower
mobile device. Refer to
page 112 .
3. Do a pairing operation of the product and the
®
Automower Connect app. Do the EPOS
®
in the Automower Connect app. Refer to
™
the EPOS setup on page 111 .
4. Install the charging station. Refer to
charging station on page 112 .
5. Install the reference station. Refer to
the reference station on page 113 .
6. Make a map with work areas, stay-out zones,
transport paths and maintenance points. Refer to
Installation of the map objects on page 116 .
7. Use Automower ® Connect app to do settings for
Automower
the product. Refer to
page 112 .
Note:
For more information about settings in the
app, read the Operator's manual for the robotic
lawn mower.
39.10.1 Installation tools
• Screwdriver, Torx 20.
• Hex key, 4 mm. Included in the carton.
• Hex key, 8 mm. Included in the carton.
39.10.2 To install the EPOS plug-in
1. Remove the top cover on the robotic lawn mower.
1944 - 001 - 13.01.2023
To install the
Connect app on your
®
Automower Connect on
™
setup
To do
To install the
Installation of
® Connect on
2. Remove the 4 screws (Torx20) and the cover
plate.
3. Remove the sealing plug on the connector.
4. Connect the cable from the EPOS plug-in to the
robotic lawn mower.
5. Install the EPOS plug-in with 4 screws.
6. Install the top cover.
39.10.3 To do the EPOS
When the product is set to ON for the first time, there
are some basic settings to do before the product can
™
setup
Installation - 111