Husqvarna Automower EPOS Plug-in Kit Bedienungsanweisung Seite 108

stops after reversing from the charging station.
The reversing distance can be set to 70-250 cm /
28-98 in. Make sure that there is minimum 3 m (C)
between objects that are higher than 1 m / 3.3 ft.
around the docking point (B).
C
B
B
C
• If the product must not operate in a part of the
docking area, put a protective wall that is minimum
15 cm / 6 in. in height. The docking area (A) is
a circular area around the charging station with a
radius of 3 m / 9.8 ft.
108 - Installation
A
A
•
•
•
•
39.7 To examine where to put the
power supply
Note:
The product uses the charging station
signal to search for the charging station when it
is in the docking area.
Put the charging station near a power outlet.
Put the charging station on a level surface.
The baseplate of the charging station must not be
bent.
max. 5 cm / 2"
max. 5 cm / 2"
If the work area has 2 parts separated with a steep
slope, Husqvarna recommends to put the charging
station in the lower section.
CAUTION:
Do not install the charging
station where there are metal objects
in the ground. Metal objects can cause
interference with the charging station signal.
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
A
1944 - 001 - 13.01.2023