Storage - Cleanmaxx ND8803-1 Bedienungsanleitung

EN
Emptying the Dust Container
1. Press the release button (19) of the
dust container (3) and pull it out of the
device by the carrying handle (10).
2. Hold the dust container over a dustbin.
3. Slide the release button (A) for open-
ing the dust container downwards.
The bottom (12) of the dust container
will open and the dirt will fall out (Pic-
ture H).
4. Flip the bottom of the dust container
shut again. You must hear it engage
in place.
Cleaning the Dust Container,
Cyclone Insert and EPA Filter
1. Take the dust container (3) out of the
device and empty it (see "Emptying
the Dust Container").
2. Twist the lid (11) of the dust container
anticlockwise towards the
on the dust container and take off the
lid (Picture J).
3. Pull the cyclone insert out of the dust
container and remove the EPA fi lter.
4. Tap out the cyclone insert and the
EPA fi lter and brush off loose dirt with
a soft brush.
The dust container, the cyclone insert
and the EPA fi lter can also be cleaned
under running water. However, they
must be completely dry before they
are reinserted!
Assembly
1. Insert the EPA fi lter into the cyclone
insert. The fi lter holder must be facing
upwards.
2. Insert the cyclone insert into the
dust container (3). When you do this,
make sure that the locking lug fi ts in
the corresponding recess in the dust
container.
3. Place the lid (11) on the dust con-
tainer so that the left marker on the
lid points towards the arrow tip on
16
03040_Inlay_de-en-fr-nl_A5_V1.indb 16 03040_Inlay_de-en-fr-nl_A5_V1.indb 16
the dust container. Twist it clockwise
towards the
4. Insert the dust container into the
device (see the "Assembly" chap-
ter – "Removing / Inserting the Dust
Container"). It must engage audibly.
Cleaning the Exhaust Air Filter
The exhaust air fi lter (16) is located on the
back of the vacuum cleaner (Picture C).
1. Press down the locking lug of the cov-
er and open up the cover at the same
time. Then take off the cover.
2. Remove the exhaust air fi lter from the
cover and tap it out over a dustbin.
Do not wet-clean the exhaust air
fi lter!
3. Brush or wipe out the fi lter compart-
ment if necessary.
4. Insert the exhaust air fi lter into the
cover.
symbol
5. Insert the cover and fl ip it shut. You
must hear it engage.

STORAGE

• Hook the fl oor nozzle (1) into the
holder (17) on the back of the device
(Picture I) and collapse the telescopic
tube (5).
• Store the device in a cool, dry place
which is protected from direct sunlight
and is out of the reach of children and
animals.
symbol (Picture J).
11.02.2022 13:06:49 11.02.2022 13:06:49