GGMgastro GSH360 Bedienungs- Und Wartungsanleitung Seite 28

H3
INSUFFICIENT WASH WATER TEMPERATURE
This alarm is displayed if, during the cycle,
the wash phase is carried out at least 10°C lower
than the set temperature
EN
F1
DOOR OPEN WARNING
This warning is displayed when the door is open.
The warning remains displayed until the door
is closed again.
F2
TANK WATER FILL-UP
This warning is displayed when the machine is
filling water (only during the initial fill-up phase -
only with the starting temperature control active).
C1
DRAIN and SELF-WASHING CYCLE
This warning is displayed when the machine is
running the SELF-WASHING cycle.
C2
DRAIN CYCLE
This warning is displayed when the machine is
running the DRAIN cycle.
NO TANK FILL-UP DURING CYCLES
This alarm is displayed if the tank does not fill up to the
pressure switch level during the wash cycles.
The display will show the set-point temperatures and
the START key will light up STEADY YELLOW.
WASH
The alarm can be reset by turning the machine off
and on by pressing the START key.
28
RINSE
3.3 RINSE AGENT LIQUID
DOSAGE with
a HYDRAULIC PUMP (Fig. 8)
Make sure that the suction hose (13) of the rinse agent
is inserted correctly into the tank (12). It will be dosed
by actuating the adjustment screw, which after be-
ing fully closed, must be unscrewed by two complete
turns.
3.3.a MACHINES with no BT
Fill the dispenser hose by turning the machine on by
pressing the "START" key and bring it to the adequate
temperature. Start the washing cycle, and during this
cycle, open and close the door several times until the
rinse agent has reached the dispenser.
3.3.b BT MACHINES
Fill the dispenser hose by turning the machine on by
pressing the "START" key without inserting the
overflow.
Wait for the boiler to reach the adequate temperature
for the first tank fill-up. When the tank starts being filled,
open and close the door several times until the rinse
agent has reached the dispenser. If the rinse agent
has not reached the dispenser, wait for the boiler to be
restored, for the boiler to heat up and then repeat the
previous steps.
3.3.c CHECK PROCEDURE
Once the steps described above have been carried
out, insert the overflow for the tank to be filled. Then
wait for the machine to reach an adequate temperature
("Green" or "Flashing green" START key). Then try to
wash. If the washed items have drops, it means that
the amount of rinse agent is too little. If rings appear, it
may mean there is too much rinse agent or excessive
water hardness.
The adjustment can vary depending on the type of
rinse agent. At this point, the machine automatically
draws the necessary liquid for each rinse: during the
washing steps, check that the liquid in the container
does not run out.
3.4 DETERGENT LIQUID
DOSAGE (Fig. 8)
(only for machines with an incorporated
dispenser)
Fully close the dispenser adjusting screw, and then
slowly open it until the recommended amount by the
manufacturer is reached. Turn on the machine and
wait for the machine to reach the adequate tempera-
ture. Then run an empty cycle to dose the product.
Check that the correct amount of detergent is drawn
during the rinse (1 cm = approx. 1g).