GGMgastro GSH360 Bedienungs- Und Wartungsanleitung Seite 17

2.1.c STARTING the WASH CYCLE
ATTENTION
I
t is recommended to check the level of detergent
and rinse agent daily.
IMPORTANT
The MANUAL or AUTOMATIC
(by closing the door) cycle start-up mode must be
changed by an authorised technician.
STARTING the MANUAL WASH CYCLE
Press the START key to start the
wash cycle.
The START key turns BLUE during the entire duration
of the wash cycle.
The countdown of the cycle appears on the display in
seconds. Any other alarm messages will be displayed
on the right.
The following phases are performed during a complete
cycle:
° WASH
° PAUSE
° RINSE
° DRAIN
During the cycle you can display the
ACTUAL temperature by pressing the
BACK key.
THERMOSTOP FUNCTION
If the rinsing temperature is not ADEQUATE at the
end of the washing phase, the COUNTDOWN on the
display stops, so as to indicate the intervention of the
thermostop. The washing phase will last for as long as
is necessary to reach the MINIMUM GUARANTEED
RINSE temperature, equal to the value:
T°setpoint – set thermostop value.
Once the set temperature value is reached, the count-
down resumes until the cycle is completed.
WASH
Any other messages will be displayed on the right.
The pause to reach the ideal temperature can be pro-
longed to a maximum of 8 minutes.
After this time, the washing and rinsing cycle is com-
pleted and the H1 alarm will appear on the right side
of the display.
WASH
During the thermostop you can display
the ACTUAL temperature by pressing
the BACK key.
RINSE
RINSE
2.1.d INTERRUPTING the CYCLE
The wash cycle can be temporarily interrupted in two
ways:
1) F1 appears on the display:
• When the door is opened.
• When the door is closed again, the cycle resumes
from where it stopped.
WASH
Once the wash cycle is completed, the SET temperatures
appear on the display.
WASH
The START key turns STEADY GREEN
(indicating that the machine is ready for
the next cycle).
At the end of the wash cycle, remove the dish rack and
shake it gently to remove the last drops on the washed
items.
Let the objects dry and remove them from the dish rack
with clean hands.
Set everything on hygienic and stable surfaces.
2) Turn off the machine by keeping
the START key pressed for 5 sec.
This way, every active cycle is interrupted definitely
and the machine is set to OFF.
WASH
When switched on again, the LED associated with the
last selected cycle will light up and the display will in-
dicate the alarm code "A1" that will disappear when a
new cycle begins.
WASH
2.1.e DRAINING WATER FROM THE TANK
2.1.e .1 MACHINE DRAIN without a DRAIN PUMP
The water in the tank can be emptied at any time of
the day depending on the accumulated filth.Proceed
as follows to perform this operation:
- SWITCH OFF the dishwasher by
pressing the START key for 5 sec.
- OFF appears on the
display.
- Release the overflow by turning it anti-clockwise (14),
allowing the water to drain completely from the tank;
- Extract the tank filter (15) and clean it.
At the end of the cycle, put the filter (15) and the overflow
(14) back into the respective seats.
RINSE
RINSE
RINSE
RINSE
WASH RINSE
EN
17