Connection Cable - Electrolux DMGL8322UO Benutzerinformation

10 www.electrolux.com
INTEGRATED INSTALLATION
750-780
Find the video tutorial "How to install
your Electrolux Extractor Hob 80 cm" by
typing out the full name indicated in the
graphic below.
830
515
830
515
15,5
750-780
521
Filter housing assembly
Before first use make sure to insert the
filter inside the housing, with the black
sides facing inwards and the silver sides
facing out. Refer to "Cleaning the hood
filter". Once the filter housing is
assembled, put it inside the hood cavity
and place the grid on the hood.

3.6 Connection cable

• The hob is supplied with a connection
cable.
8
28-43
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
836
withstands a temperature of 90 °C or
higher. The single wire must have a
diameter of minimum 1,5 mm². Speak
to your local Service Centre. The
connection cable may only be
replaced by a qualified electrician.
One-phase connection
1. Remove the cable end sleeve from
black and brown wires.
2. Remove an insulation of the brown
and black cable ends.
3. Merge the black and brown cable
ends.
4. Apply a new wire end sleeve on the
common cable end (special tool
required).
www.youtube.com/electrolux
www.youtube.com/aeg
How to install your Electrolux
Extractor Hob 80 cm
WARNING!
All electrical connections
must be made by a qualified
electrician.
CAUTION!
Connections via contact
plugs are forbidden.
CAUTION!
Do not drill or solder the wire
ends. It is forbidden.
CAUTION!
Do not connect the cable
without cable end sleeve.