Electrolux DMGL8322UO Benutzerinformation Seite 9

Integrated installation
1. Clean the rabbets in the worktop.
2. Cut the supplied 3x10 mm seal stripe
into four stripes. The stripes must
have the same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not stretch the stripes. Do not bond
the ends of the stripes one over the
other.
After you assemble the hob, seal the
remaining gap between the glass
ceramic and the worktop with silicone.
Make sure the silicone does not get
under the glass ceramic.
3.5 Assembly
Refer to the installation booklet for
detailed information on how to assemble
your hob.
Follow the hob connection diagram and
the window switch connection diagram (if
applicable) presented in the installation
booklet and / or the labels under the hob.
Only for selected
countries
In case of exhaust
installation a window switch
might be required (consult
an authorised technician).
You need to buy it
separately as it is not
supplied with the hob. The
window switch has to be
installed by an authorised
technician. Refer to the
installation booklet.
min.
500mm
If the appliance is installed above a
drawer, the hob ventilation can warm up
the items stored in the drawer during the
cooking process.
ON-TOP INSTALLATION
750-780
ENGLISH 9
min.
50mm