Cleaning The Filter - Electrolux DMGL8322UO Benutzerinformation

3. Gently push the two elements from
the outside in and fold them together.
Then take out the filter from the filter
housing.
4. Reassemble the filtering unit after
cleaning:
a. Slide the filter elements inside
the filter housing along the built-
in runners. Make sure that the
black sides are facing inwards
and the silver sides are facing
out.
b. Place the filter housing back
inside the hood cavity.
Cleaning the filter housing
Wash the filter housing manually using a
mild detergent and a soft cloth. You can
also wash it in the dishwasher.

Cleaning the filter

1. Wash the filter in warm water using a
mild cleaning agent.Wash the filter in
warm water without any cleaning
agents. Detergents can damage the
odour filtration. You can use a soft
sponge, a soft cloth, or a non-
abrasive cleaning brush to remove
food remains, if necessary. You can
also wash the filter in a dishwasher at
65-70 °C (using a program longer
than 90 min), without detergents and
without dishes in the same load.
2. Dry the filter in the oven for 20-30
min at 70 °C. Place the filter on the
middle wire shelf. Make sure to use a
non-fan oven function. Alternatively,
you can leave the filter to dry
overnight at room temperature. The
filter needs to be fully dried before
reassembly.
3. Reassemble the filtering unit and put
it back inside the hood cavity.
4. If the notification
briefly to reset the counter.
The counter restarts.
Regenerating the filter
1. Clean the filter first, as described
above in step 1.
2. Put the filter in the oven set to
80-110 °C for 60 min. Place the filter
on the middle wire shelf. Use a non-
fan oven function.
3. Reassemble the filtering unit and put
it back inside the hood cavity.
4. Press briefly to reset the counter.
The counter restarts.
ENGLISH 23
is on, press