Installation; Connection Cable; Before The Installation; Built-In Hobs - Electrolux GK29TCIO Benutzerinformation

• Disconnect the appliance from the
mains supply.

3. INSTALLATION

WARNING!
Refer to Safety chapters.

3.1 Before the installation

Before you install the hob, write down the
information below from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................

3.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
During installation in combustible matter,
NIN SEV 1000 and fire protection
guidelines and regulations of the
3.5 Assembly
ON-TOP INSTALLATION
min.
500mm
• Cut off the mains electrical cable
close to the appliance and dispose of
it.
Association of Cantonal Fire Insurance
shall be strictly adhered to.

3.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
withstands a temperature of 90 °C or
higher. Contact an Authorised Service
Centre. The connection cable may
only be replaced by a qualified
electrician.
3.4 Electrical connection
Install the hob with a socket supply line.
If there is no socket supply line, the fixed
home electrical system must include an
isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000).
min.
50mm
min.
2mm
ENGLISH 7