Electrolux DMGL8322UO Benutzerinformation Seite 22

22 www.electrolux.com
latches out and open them one by one.
WARNING!
Make sure you do not let
water get inside the hood.
If water or other liquids spill inside the
hood system:
• switch off the hood in the first place,
• lift the grid and clean the hood area
carefully with a moist cloth or sponge
and a mild cleaning agent,
• wipe away the excess liquid gathered
on the bottom of the hood cavity using
a sponge or a dry cloth,
• clean the filter, if needed (refer to
"Cleaning the hood filter"),
• switch on the hood, set the fan speed
level to 2 or higher and let it run for
some time to get rid of the remaining
moisture.
9.4 Cleaning the hood filter
The hood filter prevents grease particles
from getting into the hood system. The 2-
in-1 long life carbon filter combines the
filtration of grease and odour in one unit.
The filter consists of two elements
located on the left and right side of the
filter housing. Each element is made up
of the grease filter and the long life
carbon filter. The grease filter collects
grease, oil, and food remains and
prevents them from getting into the hood
system. The long life carbon filter,
containing active carbon foam,
neutralises smoke and cooking smells.
Clean the filter regularly and regenerate
it periodically:
• Clean the filter as soon as the built-up
grease is visible. The cleaning
frequency depends on the amount of
fat and oil used in cooking. It is
recommended to clean the filter every
10-20 hours, or more frequently, if
needed.
• The hob has a built-in counter with a
notification that reminds you about
cleaning the filter. The counter for the
notification starts automatically when
you turn on the hood for the first time.
After 100 hours of use the filter
indicator starts blinking to signal
that it is time to clean the filter. The
notification stays on for 30 seconds
after you deactivate the hood and the
hob. The notification does not block
the use of the hob.
• Regenerate the filter only when the
notification is on. The maximum
number of regeneration cycles is 7.
After that time, the filter needs to be
replaced with a new one.
The hob has a built-in counter with a
notification that reminds you about
regenerating the filter. The counter for
the notification starts automatically
when you turn on the hood for the first
time. After 100 hours of use the filter
indicator starts blinking to signal
that it is time to regenerate the filter.
The notification stays on for 30
seconds after you deactivate the hood
and the hob. The notification does not
block the use of the hob.
WARNING!
An oversaturated filter can
pose a risk of fire.
Disassembling / reassembling
the filter
The filter and filter housing are located
right under the grid in the centre of the
hob. Remove them carefully as they
might be slippery due to accumulated
grease.
1. Remove the grid.
2. Take out the filter housing.