Sennheiser EK 4015 UHF Gebrauchsanleitung Seite 11

Switching on the receiver
The device is switched on by means of switch
After approx. 2 seconds, the control LED „POWER"
(display ) lightens. The receiver is now ready for
operation and the PLL has locked on the frequency
adjusted.
Selecting a receiving channel
The selector switch
range A and B. Each range offers 16 channels. The
channels can be selected by means of the rotary
switch .
An overview of the 32 selectable receiving
frequencies is located on the opposite device side.
AF connection
The floating and balanced AF signal is available at
the LEMO socket
this output signal to the input sensitivity of the
subsequent amplifier:
Position „HIGH", 3.2 V/10 kΩ:
In this position, the EK 4015 receiver
can directly be connected to a Line input.
Position „LOW", 30 mV/600 Ω:
In this position, the EK 4015 receiver can
directly be connected to a microphone input.
The XLR plug of the XLR adapter cable enclosed
features an attenuator which can be adjusted by means
of a small screw driver. Setting range: 0 to -40 dB.
allows to switch between
. Switch allows to adapt
.
11