Troubleshooting; Possible Cause - Dexter 3901324953 Originalbetriebsanleitung

19. Troubleshooting

Fault

Possible cause

Saw blade is loose
after the motor is Fixing nut not tight enough
switched off
Mains fuse blown
Extension cable defective
Motor does not start
Connection to the motor or switch
not OK
Motor or switch faulty
Cross section of the extension cable
Motor not supplying
insufficient
power, fuse tripping
Overload due to blunt saw blade
Blunt saw blade
Burnt areas on the
cutting surface
Incorrect saw blade
Incorrect motor rota- Capacitor defective
tional direction
Incorrect connection
Direction of rotation
Remedy
Tighten fixing nut, right-hand thread
Check mains fuse
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
see "Electrical connection"
Replacing the saw blade
Have an authorised sharpening service sharpen the
saw blade or replace it
Replace saw blade
Have this checked by an electrician
Have an electrician transpose the wall plug poles
GB | 45