Unpacking; Assembly - Dexter 3901324953 Originalbetriebsanleitung

Tilting saw blade
Extraction connection
Weight
*S1:Continuous operation with constant load
**S6 20 %:
Continuous duty with intermittent loading (operating
time 10 min.)
To avoid impermissible overheating of the motor, the
motor should be driven for only 20% of the operating
time with the stipulated nominal power and must then
continue to run with no load for the remaining 80% of
the operating time.
Noise level
The noise values have been determined in accord-
ance with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
m WARNING!
Excessive and frequent exposure to noise can lead to
hearing damage or hearing loss.
- Wear hearing protection
- Take breaks.
Total vibration values (vector sum of three directions)
determined according to EN 62841.
NOTE: The specified noise emission values have
been measured in accordance with a standardised
test procedure and can be used to compare one pow-
er tool with another.
The specified noise emission values can also be used
for an initial estimation of the exposure.
WARNING: The noise emission values can vary
from the specified values during the actual use
of the power tool, depending on the type and the
manner in which the power tool is used, and in
particular the type of workpiece being processed..
Implement measures to protect against noise nui-
sance.
In doing so, take into account the complete working
process, including the times when the power tool is
working without load or switched off.
Suitable measures include regular maintenance and
care of the power tool and the insertion tools, regu-
lar breaks as well as proper planning of the working
process.
36 | GB
From -2 to 45 ° left
ø 35 mm
approx. 29 kg
96.8 dB(A)
3 dB
109.8 dB(A)
3 dB

7. Unpacking

m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, packaging and
transport safety devices (if applicable).
• Check the completeness of the scope of delivery.
The customer service must be notified immediately
of any complaints. Later claims will not be recog-
nised.
• Check the scope of delivery for transport damage.
The transport company must be notified immedi-
ately of any complaints. Later claims will not be rec-
ognised.
• Keep the packaging until the end of the warranty
period.
• Read through the operating manual completely.
• Only use original spare parts or accessories. Origi-
nal spare parts or accessories can be obtained from
your dealer.
• Check that the data on the type plate matches with
the mains power data.

8. Assembly

m WARNING: Remove the mains plug before main-
taining, modifying or assembling the circular table
saw.
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
You require the following for assembly:
• 2x open-ended spanner 8/10 mm (38)
• 1x Allen key 5 mm (39)
(included in the scope of delivery)
• 1x Phillips screwdriver
• 1x slotted-head screwdriver
(not included in the scope of delivery)
• Place all supplied parts on a flat surface.
• Group equal parts.
NOTE:
• If connections are secured with a screw (round-
head or hexagon), hexagon nuts and washers, the
washer must be fitted under the nut.
• Insert screws each from outside to inside. Secure
connections with nuts on the inside.