Transport; Maintenance - Dexter 3901324953 Originalbetriebsanleitung

1. Remove dust and chips with a brush after each
working operation.
2. Clean the ventilation holes with a lint-free cloth.
13.2 Clean the product with compressed air
ATTENTION!
Product damage due to use of a compressed air de-
vice with too high of a pressure
By cleaning the product with highly compressed air,
electrical components may become damaged.
- Use a compressed air device with a low pressure
of max. 2 bar.
- Do not use the compressed air device for the la-
ser.
1. Always keep enough distance to the product.
2. Remove dirt with a compressed air device (max.
2 bar).
13.3 Cleaning the chip extraction system
A chip extraction system is not included in the scope
of delivery. Follow the manufacturer's operating in-
structions to properly clean the extraction system.

14. Transport

m WARNING!
Danger of injury due to unexpected start-up of the ma-
chine
- Remove the mains plug from the socket.
14.1 General notes
• Hold the product at the gripping surfaces.
• Package the product to prevent transport damage.
Use the original packaging.
• Protect the product from vibrations and shocks, in
particular during vehicular transport.
• Ensure adequate load securing when transporting
in a vehicle.
14.2 Product-specific notes
m WARNING!
Danger of injury due to excessive product weight.
- Ask a second person to help you mounting the
product.
1. When lifting the product, note its weight see tech-
nical data.
2. Always switch off the power tool before transport
and disconnect it from the power supply.
3. Always carry the power tool with at least one oth-
er person, do not carry by the table extensions.
To transport the power tool, lift it by the machine
housing.
4. Protect the power tool from impacts, shocks and
severe vibrations, e.g. during vehicular transport.
5. Secure the power tool against toppling and slip-
ping.
42 | GB
6. Never use protective devices for handling or
transport.

15. Maintenance

m WARNING!
Danger of injury due to unexpected start-up of the ma-
chine
- Remove the mains plug from the socket.
m WARNING!
Warning against unexpected hazards and damages
to the product
- Never carry out unauthorized changes or repairs
to the product that are not described in the oper-
ating manual.
- Do not carry out work on the product described
for a specialist workshop.
15.1 General notes
• Check the product for loose, worn or damaged com-
ponents.
• Check the nuts, pins and screws for firm seating.
• Check the covers and protective equipment for
damage and correct seating.
• Check the electrical connections. Repairs to the
electrical connections may only be carried out by a
specialist workshop.
15.2 Oiling the product
1. Oil the rotating parts once monthly to extend the
life of the tool.
2. Do not oil the motor.
15.3 Servicing carbon brushes
ATTENTION!
Product damage
- The carbon brushes must only be replaced by an
electrician.
If excessive sparks are generated, have an electrician
check the carbon brushes.
15.4 Replacing the saw blade
m WARNING!
Danger of injury! Improper handling of the circular ta-
ble saw may result in serious injury.
m WARNING!
Danger of injury due to unexpected start-up of the ma-
chine
- Remove the mains plug from the socket.
m WARNING!
Danger of injury for fingers and hands due to sharp
edges
- Wear protective gloves.