Introduction; Device Description - Dexter 3901324953 Originalbetriebsanleitung

1. Introduction

Manufacturer:
Adeo Services
135 rue Sadi Carnot - CS 00001
59790 Ronchin - France
Dear customer
We hope your new tool brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling,
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating man-
ual before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions include important instruc-
tions for the safe, proper and economic operation of
the machine, for avoiding danger, for minimising re-
pair costs and downtimes and for increasing the reli-
ability and extending the service life of the machine.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the machine in your country.
Keep the operating manual package with the ma-
chine at all times and store it in a plastic cover to pro-
tect it from dirt and moisture. They must be read and
carefully observed by all operating personnel before
starting the work.
The machine may only be used by personnel who
have been trained to use it and who have been in-
structed with respect to the associated hazards. The
required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your coun-
try, the generally recognised technical rules relating
to the operation of such machines must also be ob-
served.
30 | GB
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description

1. Left table width extension
1a. Table width extension right
2. Parallel stop
2a. Stop rail
2b. Wing nut
2c. Coach bolt
2d. Eccentric lever
3. Saw blade
3a. Inner saw blade flange
3b. Outer saw blade flange
3c. Drive shaft
3d. Fixing nut
3e. Reducer ring
4. Riving knife
4a. Fixing screw
5. Saw blade guard
5a. Screw
5b. Quick locking button
6. Table inlay
6a. Countersunk head screw
7. Transverse stop
7a. Stop rail
7b. Wing nut
7c. Locking handle
8. Front chain bar
9. Speed selection switch
9a. High speed switch
9b. Low speed switch
10. Locking lever
11. On/off switch
11a. Cover On/Off switch
12. Overload switch
13. Crank wheel
14. Scale
15. Rubber foot
16. Tilt protection bar
17. Centre strut short
18. Centre strut long
19. Leg
20. Table support long
20a. Table support short
21. Extraction port
22. Back chain bar
23. Extraction hose
24. Push stick
24a. Wooden push block (not included in the scope
of delivery)
25. Rail joiner
26. Scale
27. Screw for scale M4 x 6 mm
28. Washer
29. Hexagon screw M6 x 12 mm