Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
The selected
programme will not
start or it stops.
The display
(18) is
illuminated although
dishwasher salt has
been added.
The water is not
running or it is running
only very slowly.
The water is not
running off or only
very slowly.
The dishwasher is not
watertight.
The dishwasher can
be switched on/off,
but not cannot be
operated.
Possible cause
The dishwasher's door is not
closed properly.
The water tap is not properly
on.
The inlet hose is defective.
There is a risk of overflowing.
The electrical water stop
system has been activated.
The dishwasher salt is clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
Troubleshooting table
Solution
Close the dishwasher door.
Turn the water tap on
completely.
Contact our Service
department (see page EN-40).
Stir the dishwasher salt using
the end of a spoon or similar.
Arrange the inlet hose
properly so that it is not kinked
(please see "Connect the inlet
hose" on page EN-30).
Turn the water tap on
completely.
Clean the filters (see
"Checking and cleaning the
filters" on page EN-27).
Lay out the outlet hose in
the proper manner (see
page EN-29).
Have the door seal replaced
(see „Service" on page EN-40).
Have the defective hose
replaced (see "Service" on
page EN-40).
Close the door.
Page EN-37
Werbung
Inhaltsverzeichnis
