hanseatic HGTI6082C147735TS Gebrauchsanleitung Seite 59

Dishwasher detergents, rinse aids and dishwasher salts
Add rinse aid:
– prior to the first use,
– when the "Add rinse aid" indicator lights up
(17).
As rinse aid is automatically dispensed during
operation, it ensures that the dishes are spot-
free and accelerates the drying process.
1. Open the cover to the rinse aid compart-
ment (38).
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the cover to the rinse aid compart-
ment again.
Changing rinse aid setting
We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Quickly take the following steps, otherwise in-
terrupt the process from (see "Adjusting the
water hardness level" on page EN-35).
1. Switch the appliance on using the sensor
(1).
2. Press the P sensor (2) for 5 seconds with-
in 60 seconds of switching on.
3. Push the sensor (3) to switch to the
setting mode.
The indicator (17) will flash. The cur-
rent value (d1 to d5) will illuminate on the
display (5).
4. Select the desired dose using the P sen-
sor (2): from d1 (low) to d5 (high).
5. The appliance will save the setting after 5
seconds, and the display will return to the
original indicator.
Page EN-15