Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
device complying with overvoltage
category III must be connected into
the house wiring with a contact gap
of at least 3 mm; consult a qualified
professional if necessary (see "Ser-
vice" on page EN-40).
■ We recommend using a pulse-sensi-
tive residual-current device (RCD).
■ The appliance must only be connect-
ed to the mains after completion of
all installation and assembly work.
■ Do not put any objects in or through
the housing openings and also make
sure that children cannot insert any
objects through them.
■ Keep the appliance, the mains plug
and the mains cord away from open
flames and hot surfaces. The insula-
tion of the mains cord could melt.
■ Do not kink or pinch the mains cord
or lay it over sharp edges.
■ Never pull the mains plug out of the
socket by the mains cord; always hold
the mains plug itself.
■ Never touch the mains plug with wet
hands.
■ Never immerse the mains cord or plug
in water or any other liquids.
■ In the event of a fault, as well as be-
fore cleaning or maintenance, pull
out the mains plug/switch off or un-
screw the fuse.
■ Never clean the appliance with a
high-pressure cleaner or steam clean-
er.
Safety
This appliance contains electrical and
mechanical parts which are essential
for protection against potential sources
of danger.
■ Only parts corresponding to the orig-
inal appliance specifications may be
used for repairs.
■ Investigations and repairs to the ap-
pliance may only be carried out by
authorised specialists, such as our
Service department.
Unauthorised repairs to the appliance
can cause property damage and per-
sonal injury, and invalidate liability and
warranty claims.
■ Never try to repair a defective or sus-
pected defective appliance yourself.
■ If the supply cord is damaged, it must
be replaced by the manufacturer, the
manufacturer's service agent or a
qualified expert in order to avoid haz-
ards.
■ Check the appliance regularly for
damage.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fire.
■ Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
■ Do not operate the appliance with an
external timer or a separate remote
control system.
Page EN-5
Werbung
Inhaltsverzeichnis
