Troubleshooting - Scheppach 5903112901 Originalbetriebsanleitung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices.
Improper handling of waste equipment may have neg-
ative consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are
also contributing to the effective use of natural resourc-
es. You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.

17. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
The engine starts
slowly and does not
reach the operating
speed.
Engine producing
excessive noise.
Engine does not reach
full power.
Motor overheats easily.
Possible cause
Engine, cable or
connector defective.
Voltage too low, coils
damaged, capacitor burnt.
Coils damaged, motor
defective.
Circuits in the network are
overloaded (lamps, other
engines, etc.)
Overloading of the engine,
insufficient cooling of the
engine.
www.scheppach.com
Remedy
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the same
circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.
GB | 35