Setup Menu: Level 2; General; Changing Welding Parameters; Exiting The Setup Menu - Fronius TransPocket 4000 CEL Bedienungsanleitung

Setup menu: level 2

General

The Eln (characteristic selection), r (welding circuit resistance), L (welding circuit
inductivity display) and ASt (anti-stick) functions are located in a second menu
level.
Changing to the second menu level (2nd)
1
2
3
4
The power source is now in the second menu level (2nd) of the Setup menu. The
Eln function (characteristic selection) is displayed.
Changing wel-
1
ding parameters
2
Exiting the Set-
up menu
Level 2 Setup menu
98
Select the "2nd" parameter as described in the section "Setup menu: level 1"
Press and hold the Setup / Store (7) button
Press the Process button (3)
Release the Setup / Store (7) button
Use the Process button (3) to select the desired parameter
Use the adjusting dial (1) to alter the value of this parameter
Press the Setup / Store button (7)
1
IMPORTANT! Any alterations are
saved by exiting the second menu level
(2nd).
A complete list of parameters for the
"Setup menu: level 2" can be found in
the section headed "2nd parameter".