Mma Welding; Safety; Preparation - Fronius TransPocket 4000 CEL Bedienungsanleitung

MMA welding

Safety

Danger from incorrect operation.
This can result in serious injury and damage to property.
▶
▶
▶
Risk of electric shock.
An electric shock can be fatal. If the device is plugged into the mains during in-
stallation, there is a high risk of serious injury and damage to property.
▶
▶

Preparation

1
2
3
4
5
6
MMA welding
Risk of electric shock.
This can result in serious injury and damage to property.
▶
1
2
The welding voltage is applied to the welding sockets with a 3-second time lag.
WARNING!
Do not use the functions described here until you have fully read and un-
derstood the following documents:
These Operating Instructions
All the Operating Instructions for the system components, especially the
safety rules
WARNING!
Only carry out work on the device if the mains switch is in the "O" position.
Only carry out work on the charger when it has been disconnected from the
mains supply.
Move the mains switch to the "O" position
Disconnect the mains plug
Plug the grounding cable into the current socket, depending on the type of
electrode, and fasten it in place
Use the other end of the grounding cable to establish a connection to the
workpiece
Plug the welding power-lead into the current socket, depending on the type
of electrode, and fasten it in place by turning it clockwise
Plug in the mains plug
WARNING!
As soon as the mains switch is in the "I" position, the rod electrode in the
electrode holder is live. Make sure that the rod electrode does not touch any
persons or electrically conductive or earthed parts (e.g. the housing, etc.)
Move the mains switch (8) to the "I" position (all the indicators on the control
panel will briefly light up)
Select one of the following processes using the Process button (3):
- MMA welding
- MMA welding with Cel electrode
- Special processes
89