Tr 2000 Remote Control; Tr 3000 Remote Control - Fronius TransPocket 4000 CEL Bedienungsanleitung

(6)
(7)
TR 2000 remote
control
Front and rear view of TP 4000 CEL / TP 5000
CEL power source
Parameters which can be adjusted on the remote control cannot be altered on
the power source. These parameters can only be altered on the remote control.
TR 3000 remote
control
TR 3000 remote control - view from above
Blanking cover (reserved for LocalNet connection)
Mains cable with strain relief device
(1)
(2)
(1) (2)
(3)
(1) Welding current adjuster
For selecting the welding cur-
rent
(2) Arc-force dynamic adjuster
For influencing the short-circui-
ting amperage at the instant of
droplet transfer
0 soft, low-spatter arc
100 harder, more stable arc
(1) Welding current indicator
For indicating the welding cur-
rent. Before the start of wel-
ding, the machine automatically
displays a standard value based
on the programmed parame-
ters. During welding, the actual
value is displayed.
(2) HOLD indicator
Every time you reach the end of
welding, the actual value for the
welding current is stored and
the Hold indicator lights up.
(3) Welding current adjuster
For selecting the welding cur-
rent
77