Troubleshooting; Possible Cause; Approved Cutting Gear - Scheppach 5910305967 Original Bedienungsanleitung

15. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product does not start
Motor stops during
operation
Reduced performance
(max. speed not
reached)
No oil on the chain
Unusual vibration

16. Approved cutting gear

Guide bar type
Type of saw chain

Possible cause

Battery empty
Battery defective
Overload protection has
tripped.
On/off switch defective
Motor defective
Battery empty
Battery not inserted
correctly
Battery defective
Battery depleted
Battery not fully charged
The oil tank is empty.
The oil guide groove is dirty. Clean groove
Oil pump malfunction
Guide bar or saw chain is
loose
Product malfunction
www.scheppach.com
Remedy
Charge battery
Check the rechargeable battery, if necessary, have
it repaired by a recognised electrician or replace the
rechargeable battery.
Wait until the overload protection restores the power
supply.
Repair by an authorised service centre
Repair by an authorised service centre
Charge battery
Re-insert battery
Clean contacts, replace original rechargeable battery
Replace battery
Charge battery
Fill oil tank.
Contact an authorised service centre for repair.
Check that the guide bar is firmly in place and that the
saw-chain is correctly tensioned
Repair by an authorised service centre
ROYAL 4" DG04-36-43P/
ROYAL 6" DH06-36-43P
ROYAL 4" CLQ4328/
ROYAL 6" CLQ4336
GB | 45