Disposal And Recycling; Troubleshooting - Scheppach DP55 Bedienungsanleitung

Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
If it is necessary to replace the connection cable, this
must be done by the manufacturer or their representa-
tive to avoid safety hazards.
13.3 AC motor:
• The mains voltage must be 220 - 240 V~ 50 Hz.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Engine data - type plate

15. Troubleshooting

Fault Possible cause
Motor, cable or plug defective, build-
ing circuit breaker tripped
Device does not start
On/off switch (11/10) defective
Motor defective
Base plate (1) not fastened in place.
Heavy vibrations
Drill bit not clamped centrally
Motor overheats Overloading of the motor, insufficient
easily cooling of the motor.
Motor makes exces-
Coils damaged, motor defective.
sive noise
30 | GB
.
2
www.scheppach.com

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste
disposal sites. Check with your specialist dealer or mu-
nicipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product
must be disposed of at a designated collection point.
This can occur, for example, by handing it in at an au-
thorised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling of
waste equipment may have negative consequences for
the environment and human health due to potentially
hazardous substances that are often contained in elec-
trical and electronic equipment. By properly disposing
of this product, you are also contributing to the effective
use of natural resources. You can obtain information on
collection points for waste equipment from your munic-
ipal administration, public waste disposal authority, an
authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.
Remedy
Check power outlet, mains connection cable,
mains plug. Have repair carried out by electrical
specialist. Check building circuit breakers.
Repair by customer service department
Repair by customer service department
Secure machine to a work bench or similar
Check drill bit in chuck (14)
Avoid overloading the motor while drilling, remove
dust from the motor in order to ensure optimal
cooling of the motor.
Have checked by customer service department