Cleaning Inlet Screen; Accessories - FILL-RITE RD Serie Installations- Und Bedienungsanleitung

|
Troubleshooting Guide (continued)
Symptom
Motor overheats Pumping high viscosity fluids
Clogged screen
Restricted suction pipe
Motor failure
Pump rotor lock-up
No power
Switch failure
Incorrect or loose wiring
Motor inoperative No power
Switch failure
Motor failure
Motor overheated
Incorrect or loose wiring
Fuse has blown
Bold text indicates repairs that are not serviceable by the owner; pump must be returned to the point of purchase for repairs.
Cleaning the Inlet Screen
Regular inspection and cleaning of the inlet screen on your RD Series
pump helps maintain performance and flow. Access the screen by
removing the inlet flange as described on page 6. Clean, rinse, and dry
the screen throughly before re-installing.
Inspect the screen, seals, and flange area for debris and damage. If
screen or O-rings are damaged, replace with kit KIT812SL.

Accessories

Accessory
1200KTF7018
F1810PM0
1210KTF7019
F1810HM0
FRHMN075S
fillrite.com
RD SERIES FUEL TRANSFER PUMPS
Cause
These fluids can only be pumped for short periods of time (less than the 30 min duty cycle).
Remove and clean screen.
Remove and clean pipe.
Return to place of purchase.
Clean and inspect rotor and vanes.
Check incoming power.
Return to place of purchase.
Check wiring / connections.
Check incoming power.
Return to place of purchase.
Return to place of purchase.
Switch off and allow to cool.
Check wiring / connections.
Replace 30A fuse.
10 Micron Particulate Filter Kit (Bung mount installations only)
10 Micron Replacement Spin-on Filter (Particulate) (Bung mount installations only)
Hydrosorb Filter Kit (Bung mount installations only)
Hydrosorb Replacement Spin-on filter. (Bung mount installations only)
3/4" Manual Nozzle
INSTALLATION AND OPERATION MANUAL
Solution
Description
9