Geberit Basic Instandhaltungsanleitung Seite 37

Menu item Description
Activate manual flush
[Activate manual An early manual flush can be
flush] actuated by the user placing their
hand near the IR sensor.
Set the flush time
[Flush time] Determines the duration of the
flush after one use.
Set detection time
Determines the minimum
[Detection time]
detection time within the detection
range to be recognised as a user.
Activate preflush
When the user is detected, a flush
[Preflush]
is actuated for 3 seconds if there
has been no use in the last
10 minutes.
Activate attendance flush
Flushing takes place as long as
[Attendance there is a user in the detection
flush]
range (maximum 60 seconds).
Note: This function results in a
higher level of water consumption.
Activate postflush
An additional flush of 2 seconds is
[Postflush]
actuated 3 seconds after a main
flush.
Check detection range
As an object is located in the
detection range, the red LED in
[Detection range]
the sensor window lights up and
the display in the app switches to
green. No flush is actuated.
Volumetric flow rate
To calculate the water
consumption for the statistics
function, the volumetric flow rate
of the urinal flush control must be
[Volumetric flow
specified. The volumetric flow rate
rate]
is determined by the flow regulator
in the solenoid valve. When
replacing or removing the flow
regulator, the volumetric flow rate
must be adjusted.
Presettings
[Save as
The current settings are saved in
presetting]
the app, which means they can be
transferred to other devices.
18014405597129227 © 05-2022
971.384.00.0(00)
Application
• To actuate a manual
flush during use
• To optimise the flushing
out of the urinal
ceramic, observe the
water consumption
• To prevent flushes due
to unintentional entry
into the detection range
• To wet the urinal
ceramic before use to
avoid deposits
• To ensure thorough
flushing out of the
urinal ceramic
• As background noise
• To fill the urinal trap
• To test user recognition Automatic
–
• To commission several
devices with the same
settings
Area Factory
setting
On/Off Off
1–15 s 7 s
3–15 s 7 s
On/Off Off
On/Off Off
On/Off Off
–
9 l/min
14 l/min
18 l/min
14 l/min
5–50 l/min
(user-
defined)
– –
3 / 4
37
EN