Geberit Basic Instandhaltungsanleitung Seite 32

EN
Menu item
[EN]
[DE]
32
[IntFlush]
[IntervSp]
33
[PowOnFlsh]
[NetzEinSp]
34
[DynFlush]
[DynamSpül]
35
[PreFlush]
[Vorspülng]
37
[PostFlush]
[NachSpül]
38
[AttndFlsh]
[BeglSpül]
32
Description
Interval flush
• User-controlled: A flush is
actuated at the end of the
[flush interval] (menu item
54), whereby the flush
interval is restarted with
every use. The flush time is
determined by the [interval
flush flush time] (menu item
53) value.
• Interval-controlled: A flush is
actuated at the end of the
[flush interval] (menu item
54), regardless of the
number of uses. The flush
time is determined by the
[interval flush flush time]
(menu item 53) value.
Activate power-on flush
A flush is actuated after
switching on the mains
voltage.
Activate dynamic flush
The flush time is shortened if
user frequency is high.
Activate preflush
When the user is detected, a
flush is actuated for 3 seconds
if there has been no use in the
last 10 minutes.
Activate postflush.
An additional flush of
2 seconds is actuated
3 seconds after a main flush.
Activate attendance flush.
Flushing takes place as long
as there is a user in the
detection range (maximum
60 seconds).
Note: This function results in a
higher level of water
consumption.
Application
• To fill the urinal trap in
the case of low user
frequencies
• To flush out standing
water in the pipe
(hygiene function – to
prevent stagnation)
• To perform central flush
actuation
• To confirm a function
• To reduce water
consumption in the
case of high user
frequencies (e.g. in
sports stadiums)
• To wet the urinal
ceramic before use to
avoid deposits
• To fill the urinal trap
• To ensure thorough
flushing out of the
urinal ceramic
• As background noise
Area Factory setting
[0] = Off
[1] = User-
controlled User-controlled
[2] = Interval-
controlled
On = [ON]
On
Off = [OFF]
On = [ON]
On
Off = [OFF]
On = [ON]
Off
Off = [OFF]
On = [ON]
Off
Off = [OFF]
On = [ON]
Off
Off = [OFF]
18014405597129227 © 05-2022
971.384.00.0(00)
3 / 4