Service; Appliance-Specific Safety Instructions For Hammers - Parkside PBH 800 A1 Originalbetriebsanleitung

f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety instructions
for hammers
Safety instructions for all work
■ Wear hearing protection. The effect
of noise can lead to hearing loss.
■ Use the additional handles supplied with the
appliance. Loss of control can lead to injuries.
■ Hold the appliance by the insulated handles
when you are carrying out work during which
the deployed tool may come into contact with
concealed power cables or its own power
cable. Contact with a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
■
Wear a dust mask.
Safety information for using long drill bits
■
Do not use a higher rotational speed than
the maximum permissible speed. At higher
speeds, the drill bit can bend slightly if allowed
to turn freely without being in contact with the
workpiece and this can lead to injuries.
PBH 800 A1
■ Always start drilling at a low speed and with
the drill bit in contact with the workpiece. At
higher speeds, the drill bit can bend slightly if
allowed to turn freely without being in contact
with the workpiece and this can lead to injuries.
■ Do not exert excessive pressure and only
along the length of the drill bit (no lateral
pressure). Drill bits can bend and break which
can lead to a loss of control and injuries.
WARNING! TOXIC DUST!
► Working with the tool can produce harmful/
toxic dusts which represent a health hazard
for the person operating the appliance and
for anyone else in the vicinity.
■ CAUTION, POWER CABLES! DANGER!
Ensure that you are not likely to hit power, gas
or water supply lines when you are working
with the power tool. If necessary, check with a
service line detector before you start to cut or
drill into a surface.
Residual risks!
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in relation to the power tool's design and
structure:
1. Lung damage if no suitable dust protection mask
is worn.
2. Hearing damage, if no suitable hearing protection
is worn.
3. Damage to health caused by hand-arm vibrations
if the appliance is used for extended periods or
is not properly used and maintained.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in
certain circumstances, impair active or
passive medical implants. To reduce the risk
of fatal injuries, we recommend that people
with medical implants consult their doctor
and the manufacturer of the medical implant
before operating this machine.
GB │ MT │ 41 ■