Safety Instructions - VOLTCRAFT VC252 Bedienungsanleitung

7 Safety instructions

Read the operating instructions carefully and especially observe
the safety information. If you do not follow the safety instructions
and information on proper handling in this manual, we assume no
liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
This device was shipped in a safe condition.
To ensure safe operation and avoid damaging the device, always observe the
safety information and warnings in these instructions.
Check that the measuring device is functioning correctly with a known source
before using it.
Consult a technician if you are not sure how to use or connect the device.
Measuring instruments and their accessories are not toys and must be kept out
of the reach of children.
Always comply with the accident prevention regulations for electrical equipment
when using the product in commercial facilities.
In schools, educational facilities, hobby and DIY workshops, the multimeter
must be used under the responsible supervision of qualified personnel. The
same applies when the multimeter is used by people with reduced physical and
mental capabilities.
Always ensure that the multimeter is set to the correct measurement mode be-
fore taking a measurement.
When using measuring probes with-
out protective caps, measurements
between the multimeter and the earth
potential must not exceed the CAT II
measurement category.
When taking CAT III measurements,
the cover caps must be placed on the
probe tips (max. length of exposed
contacts = 4 mm) to avoid accidental short circuits. These are supplied with
the device.
55