Rollei Fly 100pro Anleitung Seite 79

Calibrate the Quadrocopter
6. The front position LEDs [30] now light up permanently white.
7. The app displays the following status:
"Compass calibration okay".
Calibrate gyroscope
Move the two control levers [12] / [21] of the remote control [5] simulta-
neously to the 11 o'clock (left) and 1 o'clock (right) positions.
1. The position LEDs [30] and [37] of the quadrocopter [1] flash blue (rear)
and white (front) quickly.
2. The app displays the following status: "Gyroscope calibration".
3. After a few seconds, the position LEDs [30] and [37] flash slowly blue
(rear) and white (front) again.
4. The app displays the following status: "Gyroscope OK".
Search for GPS signal
Before the quadrocopter [1] is ready for flight, it needs a GPS signal from
a GPS satellite. The quadrocopter [1] automatically starts searching for this
signal.
1. The position LEDs [30] and [37] start to flash blue (rear) and white
(front) quickly. The GPS signal is searched for. The process may take a
few minutes.
2. The app displays the following status: "Waiting for GPS signal".
3. If a GPS signal has been received, the position LEDs [30] and [37] flash
slowly for a short time and then light up constantly in blue (rear) and
white (front).
4. The app displays the status: "GPS calibration completed".
79