Maintenance And Troubleshooting - Rollei Fly 100pro Anleitung

Maintenance and Troubleshooting

104
Trimming the flight attitude when GPS is deactivated
– When the quadrocopter [1] is not in GPS mode during flight, you can
trim it to ensure more balanced flight behaviour. Press and hold the
photo trigger [29] on the remote control [5] to activate the trim mode.
Press the right control lever [21] in the opposite direction of the drift
direction of the quadrocopter [1] to balance the quadrocopter [1]. For
example, if the quadrocopter [1] drifts to the left, push the right control
lever [21] to the right to balance it. The remote control [5] acknowled-
ges each press with an acoustic signal.
– Release the photo trigger [29] to exit the trim mode.
Replacing the rotor blades
– To replace a defective rotor [31] and [36], first remove the battery [4]
from the quadrocopter [1] for safety reasons. Then loosen the screw on
the side of the defective rotor blade.
– Remove the defective rotor [31] and [36] and insert a new one. Reattach
the new rotor [31] and [36] with the screw. Tighten the screw well, but
be careful not to overtighten the screw.
Note! Attention!
– The rotors [31] and [36] and rotor arms [33] are marked with A and B.
The scope of delivery includes 2 rotors each with the designation A and
B. When changing the rotors [31] and [36], always make sure that only
rotors with the same designation can be exchanged with each other.
ENGLISH