Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

First Steps

72
Charging the remote control battery
Before the first flight of the quadrocopter [1], the battery of the remote
control [5] must be fully charged. To do this, connect the supplied micro
USB cable [2] to the USB port [20] of the remote control [5]. Connect the
other end of the micro USB cable to a USB mains plug (5.0 V
included in the scope of delivery). The charging LED [24] starts to light up
red. When the charging process is finished, the charging LED [24] goes
off and the battery LED [23] lights up green. The charging process takes
approx. 50 minutes.
You can also charge the battery of the remote control [5] via a USB con-
nection on your computer. Please note, however, that this will extend the
charging process.
– If the battery of the remote control [5] only has a low charge level, the
charging LED [24] flashes red. You must then charge the battery imme-
diately.
– The battery of the remote control [5] is permanently installed and can-
not be replaced. If the battery of the remote control [5] is damaged, the
remote control [5] must be replaced.
ENGLISH
2.0 A, not

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis