Network Requirements; Network Configuration; Connecting To A Power Supply - Medion E85080 Bedienungsanleitung

NOTE!
The station list on your Internet radio is provided free of charge by the
www.vTuner.com Internet service and is updated regularly.
If a radio station is not available, this can be due to a variety of reasons
on the part of the radio station operator. However, this is not a device
fault.
When connecting to Internet radio stations, there may be temporary de-
lays due to the high number of requests. Try to establish a connection to
the Internet service again at a later time.

8.1. Network requirements

The network must meet the following requirements for the device to function as a
WiFi radio:
• The router used for the network must have a DHCP server function so it can au-
tomatically assign a network IP address to the device.
• If your router is configured in this way, you can connect your WiFi radio to the
network without further action.
9. Network confi guration
Two network configurations are possible for the Internet radio: WiFi mode (wireless)
or LAN mode (with an Ethernet cable).
• If the Internet connection is to be set up using an Ethernet cable, go to the setup
wizard and select the connection type
tings later in the system settings.
• If you have a wireless 802.11 a/b/g/n network, you can connect the Internet ra-
dio to the Internet via WiFi:
If the device is being used for the first time, you will need to select an access
point (AP) and possibly enter the network key. The radio will then always access
this AP automatically. A message will appear if the device is unable to find the
AP.

10. Connecting to a power supply

 Plug the power connector on the supplied mains adapter (model number
GME18A-120120FGR, manufacturer GME, China) into the DC IN socket on the de-
vice.
60
WIRED . You can manually change all set-