8.1. Network requirements
The network must meet the following requirements for the device to function as a
WLAN radio:
•
The router used for the network must have a DHCP server function so it can au-
tomatically assign the device a network IP address.
•
If your router is configured in this way, you can connect your WLAN radio to the
network without further action.
9. Network confi guration
•
To connect the Internet radio to the Internet, you must connect it to a wireless
802.11 b/g/n network via WLAN:
When using the device for the first time, you will need to select an access point
(AP) and, if necessary, enter the network key. The radio will then always tune in
to this AP automatically. A message will appear if the device is unable to find the
AP.
10. Connecting to a power supply
Plug the mains cable supplied (model number YN12W-0750120VZ) into the DC
IN socket on the device.
To switch on the power, switch on the radio using the On/Off switch at the side.
11. Using the device for the fi rst time
On first startup, confirm the query SETUP WIZARD START NOW? with
YES in order to start the setup wizard. .
NOTICE!
If you select NO, in the next display you can specify whether the wizard
should start the next time you switch on the device.
162 of 191
Setup wizard
Start now?
NO
YES