Used Batteries; Wall Mounted Charger; Storage - Parkside PABS 20-Li E6 Originalbetriebsanleitung

Overview of the control display (6)
on the charger (5):
Green LED lights up without battery inserted:
Charger ready.
Green LED lights up:
Battery such alleged charged.
Red LED lights up:
Battery charging.
Red LED flashes:
Battery overheated
Red + green LEDs flash:
Defective battery

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Wall mounted charger

(optional)
You can also mount the charger (5) on the
wall.
• Using dowels, place two screws
76,2 mm apart at the desired position
of a wall.
• The screw head can have a diameter
of 7 - 9 mm
• Leave the screw heads protruding at
a distance of approx. 10 mm from the
wall.
• With the openings of the wall bracket,
you can attach the charger (5) to the
two screws and pull the charger down
until it stops.
When drilling, be careful not
to damage any supply lines.
Use suitable search devices
to find these or consult an in-
stallation plan for guidance.
Contact with electrical cables
can lead to electric shock and
fire. Contact with a gas pipe
can result in an explosion.
Damage to a water pipe can
lead to property damage and
electric shock.

Storage

• Remove the battery before storing
the unit for longer periods of time
(e.g. hibernation).
• Store the battery only in a partially
charged state. During prolonged sto-
rage, 2 to 3 LEDs should be illuminated.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
• In order to keep the battery well
charged, avoid exposing the appli-
ance to extreme heat or cold in stor-
age.
• The storage temperature for the battery
is between 0 °C and 45 °C. Avoid
extreme cold or heat during storage
to ensure the battery output is not ad-
versely affected.
GB IE
21