Hardware Reset; Led Status Of Communication Module - Bosch Power Charge 7000i Bedienungsanleitung

Commissioning

5.2.6 Hardware reset

Hardware reset allows to restart the communication module.
To perform a hardware reset, it is necessary to:
▶ Press the reset button for one second with a pointed object.

5.2.7 LED status of communication module

LED display
Bright red
Flashing red
Flashing red (5 x)
Bright yellow
Yellow/ green alternately
Flashing yellow
Flashing green
Bright green
LED off
Table 2 LED status of communication module
40
Status
Connection error.
Connection to the network but no
connection to the Internet.
Connection to the WLAN deleted or failed.
Hotspot mode active, ready to connect to
WLAN.
WPS mode is active.
Connection to hotspot is established.
Connection to the router is established.
Connection to the server is established.
Communication module active and switched
in power-saving mode.
The product is switched off.
Your individual settings will not be deleted during hardware
resetting.
Procedures
In case of missing WLAN connection:
• Check wireless router. The router is not in range
or turned off.
• Reset WLAN connection if necessary
(Chapter 5.2.4, page 39).
If there is no LAN connection:
• Check LAN cable connection.
In case of no Internet connection:
• Check your router configuration.
In case of connection WLAN deleted or failed:
• The product is back into hotspot mode.
More instructions can be found in the
HomeCom Easy app.
–
Follow the instructions in the HomeCom Easy app.
The product is connecting to the HomeCom Easy app.
A connection to the server is going to be established.
In case of LED is off:
• Press briefly the connect button.
• Check the current device status with the help of
the LED.
Power Charge 7000i – 6721849906 (2022/04)