Reset Wlan Connection; Communication Module Reset Factory Settings - Bosch Power Charge 7000i Bedienungsanleitung

5.
green
red
Fig. 45 WPS connection
If the LED is red, the WPS pairing was not successful:
▶ Check the app for further steps.

5.2.4 Reset WLAN connection

NOTICE
Damage to the appliance!
The reset must not be done while the Power Charge 7000i is
starting up.
To reset the WLAN connection, it is necessary to:
▶ Switch off the power supply of the product on the
switchboard, and after two seconds approximately, switch
it back on.
As soon as the power supply is switched on, you have 20
minutes to reset the WLAN connection.
Power Charge 7000i – 6721849906 (2022/04)
4.
<2 min
off
=
App: HomeCom Easy
0010045021-001
▶ Wait until the status LED is blue.
▶ Press the connect button on the communication module
once for approx. 3 seconds until the LED briefly lights up red.
The LED flashes red 5 times. The existing WLAN connection is
reset. As soon as the LED lights up yellow, a new WLAN
connection can be established.
▶ Make sure to reconnect the product through the app. Your
settings are retained.

5.2.5 Communication module reset factory settings

By resetting to the factory settings, individual settings such as
authentication, taught-in RFID cards or WLAN passwords are
deleted.
In order to reset factory settings, it is necessary to:
▶ Switch off the power supply of the product on the
switchboard, and after two seconds approximately, switch
it back on.
As soon as the power supply is switched on, you have 20
minutes to reset the factory settings.
▶ Wait until the status LED is blue.
▶ Press the connect button on the Power Charge 7000i once
for 15 seconds, until the LED briefly lights up red for the
second time.
The LED flashes red 5 times after 10 seconds and lights up red
again briefly after 15 seconds. After this the settings are reset.
This can take up to 90 seconds.
Commissioning
39