Wps Connection - Bosch Power Charge 7000i Bedienungsanleitung

Commissioning
1.
Download App: HomeCom Easy
ANDROID APP ON
play
2.
3.
5.
<20 min
App: HomeCom Easy
Fig. 43 HomeCom Easy

5.2.3 WPS connection

To connect with WPS, the following steps are required:
▶ Switch off the Power Charge 7000i on the power supply's
switchboard and after two seconds, approximately, switch
it back on (Fig. 43, step [2]).
▶ Wait until the status LED is blue.
▶ Loosen the two screws on the front cover (Fig. 43, step [3]).
▶ Move up the rubber seal.
While the LED lights up yellow:
▶ Press the WPS button on the router.
▶ Press the connect button on the communication module.
The LED will flash green and yellow alternatively.
38
ON ON
2 sec
OFF OFF
4.
0010044552-001
▶ Press the connect button on the communication module for
1 second. The status LED will flash green and yellow
alternately.
2.
3.
1 sec
Fig. 44 WPS connection
The product is in WPS mode and will attempt to establish
the WLAN connection to the router during 2 minutes. The
status LED lights up green and yellow.
Once the connection has been established, the status LED
lights up green, and goes out after one minute.
To establish the connection to the server:
▶ Download the app and follow the instructions.
Power Charge 7000i – 6721849906 (2022/04)
W P
S
1.
yellow
green/yellow
0010045020-001