Other Display Warnings - Atag KA8074K1C Bedienungsanleitung

Solving problems

Other display warnings

Warning
The door is open:
The humidity is out of range:
The humidity is below 50%:
The temperature is out of
range:
The vibrations are too high:
After the power is restored
measured temperature is out
of range:
Charcoal filter is expired:
62
Cause/Solution
• The door has been open too long: close the door.
• If the warning keeps showing, call the service center to arrange
repairs. The appliance operates in a safe mode until it is
corrected. The appliance automatically maintains the most
suitable temperature.
The value of humidity in the compartment is outside the permitted
limits.
Ensure that the appliance is located in in a well-ventilated area and
not exposed extremely low or extremely high temperatures.
You can find more information regarding possible causes and
potential solutions for this notification in section »Tips & Tricks«.
In the event that this occurs for a longer period of time since the last
intervention on the device (change tobetting, loading bottles, opening
doors,...) may mean that moisture sensor is out of order. Contact a
service center to correct the error. The appliance will operate in safe
mode until repaired by a service technician.
We advise to refill humidity box zone to stop the notification.
The temperature in the compartment is outside the permitted limits.
You can find more information regarding possible causes and
potential solutions for this notification in section »Tips & Tricks«
In the event that this occurs for a longer period of time since the last
intervention in the device (change of setting, loading of bottles,
opening of doors,...) it may mean that temperature sensor is out of
order. Contact a service center to correct the error. The appliance
will operate in safe mode until repaired by a service technician.
The appliance will automatically maintain the most suitable
temperature.
The detected vibrations of the appliance are outside the permitted
limits.
Check that the appliance is installed correctly ("Installation and
connection").
After power is restored to the appliance, measured temperature in
the appliance is out of range. This means 3°C above or 3°C below
the setpoint temperature.
Replace the air filter.