Error Notifications - Atag KA8074K1C Bedienungsanleitung

Solving problems

Error notifications

If a component inside the appliance is failing, a notification will pop-up.
The notification will display a code. Codes for these errors can be found in the table below.
Error
Description
Code
Communication error from power board to user
E0
interface electronics.
E1 Wi-Fi module can not turn on.
E4 Wi-Fi module can not connect to Cloud Service.
E5 'Hard Pairing' process not successful.
E6 'Unpair all' process not successful.
Communication error from user interface electronics
E8
to power board.
E9 Door sensor error.
F1 Appliance's compartment fan error.
F2 Condenser fan error.
H1 Appliance's compartment humidity sensor error.
P1 Proximity sensor error.
t1 Environment temperature/humidity sensor error.
t2 Appliance's compartment temperature sensor error.
t3 Evaporator temperature sensor error.
U1 Vibration sensor error.
81 Wi-fi modul error.
In case there is a communication error between power board and user interface electronics, other
errors will not be displayed.
If any error indication on displays 'T' and 'H' is active, then other action on display is not possible.
For that there are, anyway, some exceptions:
• in case of any of alarms is active: alarm key is active (to reset active alarm),
• in case of active Key Lock mode: key lock key is active (for deactivating key lock),
• On/Off key is active, to enter Off mode with a 3 seconds press.
If several different errors are active in the same time, they will be displayed sequentially.
If after 3 hours since the user closed the message, the error is still not resolved, the error message
is displayed again.
60
Code shown on Code shown on
Display 'T'
E0
E
E
E
E
E8
E
F
F
H
P
t
t
t
U
8
Display 'H'
E0
1
4
5
6
E8
9
1
2
1
1
1
2
3
1
1