Atag KA8074K1C Bedienungsanleitung Seite 215

Installation and connection
• The appliance comes supplied with two
spacers that should be fitted in the slots
on the back of the appliance, one on either
side, near the bottom. The spacers ensure
adequate air circulation that is required for
correct appliance operation. The appliance
will operate normally without the spacers
in place; however, this could affect its
power consumption.
• Appliance dimensions are shown on the
drawing.
• If the appliance is placed in a way that
does not allow the door to be opened to
the 115° angle, the opening angle can also
be restricted to 90°. In this case, use the
door restrictors (A) supplied in the bag
containing the instruction manual. Carefully
open the door to an angle less than 90°
and insert the restrictor into the provided
opening in the lower hinge. Repeat the
same process for the upper hinge. When
inserting the restrictor into the hinge, you
may also use a small hammer.
• When the appliance is installed, its plug
should always be accessible!
• This appliance is not intended to be used
as a build-in appliance.
13