Appliance Placement - Atag KA8074K1C Bedienungsanleitung

Appliance placement

Appliance installation should be carried out by at least two persons, in order to avoid damage to the
appliance and physical injury of anyone involved.
In order to safely install the appliance and for the appliance to operate correctly, it is important to
place it onto a surface with adequate load-bearing capacity. If necessary, consult an architect/
structural engineer. The surface should be smooth and level with the floor in the room.
Installation and connection
When moving the appliance, be careful not to
push it on the floor because of potential
damages. There are two casters on the back
of the appliance housing, that make moving
the appliance around easier.
The weight of an empty appliance is
approximately 138 kg.
The weight of a fully loaded appliance is
approximately 475kg.
When the appliance is placed on the intended
surface, it should be completely level in order
to decrease vibration. To level the appliance,
use the adjustable feet at the front of the
appliance. An open wrench size 17 is required
for adjusting and fastening the feet.
11