General Problems - Atag KA8074K1C Bedienungsanleitung

The exception is error P1 (Proximity sensor), where the user can choose not to display this error
anymore. Error itself can not be disabled.

General problems

Problem
Appliance cools continuously
for a long time.
Appliance makes a noise.
LED light is not working.
Cause/Solution
• The ambient temperature is too high.
• The door has been opened for too long or too frequently.
• The door does not seal properly (the seal is dirty, the door is
misaligned or the seal is damaged, etc.).
• A larger quantity of bottles is newly inserted.
• Insufficient air circulation around the compressor and condenser.
Check that there is sufficient ventilation around the appliance.
• The appliance is cooled by a cooling system with a noise-causing
compressor. The noise level depends on the installation of the
appliance, its correct use and age.
• When you connect the appliance to the power supply, the noise
made by the compressor or liquid refrigerant may be slightly
louder. This does not indicate a fault and has no effect on the
service life of the appliance.The appliance will produce more
noise for some time.
• The appliance may temporarily produce more noise after the
door has been opened for too long or too frequently or, there is
a large amount of newly inserted bottles.
• The appliance may produce more noise when operating in a high
temperature environment.
Check if LED lighting is turned on. For additional information see
chapter »Settings/Light«.
You may not try to repair LED lighting. Please contact a service center.
Solving problems
61