Using The Device; Check The Charge Level Of The Power Bank With Compressor; Charging The Power Bank With Compressor; Charging Mobile Phones And Tablets - ULTIMATE SPEED UPK 10 A1 Originalbetriebsanleitung

Using the device

USING THE DEVICE
• Check the charge level of the
power bank with compressor
Switch on the power bank with compressor
„
by using the on/off switch for the power
6
bank with compressor
When charging, the indicator lights flash
„
�
5
The number of permanently lit indicator
„
lights shows the charge level of the power
5
bank with compressor
When the device is fully charged, all four
„
indicator lights will be permanently lit�
5
Indicator lights
Device
1 permanently lit
2 permanently lit
3 permanently lit
4 permanently lit
• Charging the power bank
with compressor
Use the power supply adapter
power bank with compressor
socket�
Plug the cable from the power adapter
the charging port (15 V
power bank with compressor
into a mains power socket�
• Charging mobile phones and
tablets
Switch the on/off switch for the power bank
„
with compressor to the 'On' position�
8
Connect the USB cable
„
(5 V /2 A) and then plug it into your
10
38 GB / IE / NI
�
8
�
6
Charge level
0%
25%
50%
75%
100%
to plug the
16
into a mains
6
into
16
/1 A) on the
9
and then plug
6
to the USB port
17
mobile phone or tablet�
Press the on/off switch on the power bank
„
�
4
Please note: You cannot charge USB devices
(e�g� mobile phone, tablet) while the power bank
with compressor is being charged�
6
• Using the integrated
compressor
Place the device on a level and non-flamma-
„
ble surface� Do not operate the device in a dusty
environment� This is a fire risk and could also
cause damage to the device�
For inflatable items with back pressure
„
(e�g� semi-inflated car tyres): switch the device
on before connecting the connecting valve
on the tyre�
Please note: Depending on the inflatable item,
you can either use the connecting valve
directly or together with the valve adapters
supplied�
Connecting the connecting valve
Open the connecting valve
„
clamp lever to an upright position�
12
Connecting without a valve adapter
„
Connect the opened connecting valve
„
into the valve on the inflatable item
15
(remove valve cap on inflatable item first if
necessary)�
Press and hold the connecting valve
„
and then lock it in position: press the
15
clamp lever towards the air hose
12
Connecting valve
„
:
13
Open the connecting valve
„
the clamp lever
12
Press the matching valve adapter
„
into the opening on the connecting valve
Fix the valve adapter
„
necting valve : press the clamp lever
15
towards the air hose
Connect the valve adapter
„
connecting valve on the inflatable item
(remove valve cap on inflatable item first if
necessary)�
15
15
13
:
15
: move the
15
:
13
�
14
with valve adapter
15
: move
15
to an upright position�
13
15
into the con-
13
12
�
14
into the
13
�