Regenerating / Charging Empty (Used, Overcharged) 12 V Batteries; Protective Function Of The Device; Overheating Protection; Maintenance And Care - ULTIMATE SPEED ULG 3.8 A1 Bedienungs- Und Sicherheitshinweise

Press the MODE selection button
mode 4. As you select the desired mode, the
appropriate LED indicator
mediately. If you take no further action, the elec-
tronic control switches on after a preset delay
to begin the charging process. In this mode the
charging current is the same as in "mode 3". If
the process runs without any problems, the LED
indicator
switches on and remains in this state until the
battery is charged. As soon as this point is
reached, the battery charger switches to main-
tenance charging mode. Now the LED indicator
goes out and the LED indicator
8
lights up to indicate the present status.
©
Regenerating / charging
empty (used, overcharged)
12 V batteries
The battery charger detects the battery voltage au-
tomatically once the battery charger is connected
to a battery and the charging process has started.
It changes to pulse charging mode if the voltage is
in the range of 7.5 V ± 0.5 to 10.5 V ± 0.5 V.
This pulse charging process is continued until the
battery voltage has increased to 10.5 V ± 0.5 V.
As soon as this state is reached, the battery charger
switches into the normal charging mode that you
selected earlier.
Now the battery can be charged quickly and safely.
Most empty batteries can be charged and used
again using this procedure.
©

Protective function of the device

If a unexpected situation should occur, such as short
circuiting, battery voltage below 7.5 V, open circuit
or reversed connection of the output terminals, the
charging station deactivates the electronic system
and immediately switches back to basic position to
avoid damage. If you do not activate any settings,
the system will remain in STANDBY mode. With the
inverse connection of the output clamps the LED
display „incorrect polarity / fault"
additionally.
Downloaded from www.Manualslib.com
Operation / Maintenance and care / Service / Warranty
to select
9
lights up im-
5
lights up, the electronic control
8
lights up
6
manuals search engine
©

Overheating protection

If the appliance becomes too hot during charging,
the power output is automatically reduced. This
protects the appliance from damage.
©

Maintenance and care

WARNING!
on the battery charger always pull the mains
plug out of the mains socket.
The appliance is maintenance-free.
7
Switch off the appliance.
Clean the plastic surfaces of the device with a
dry cloth. Do not under any circum-stances use
solvents or other aggressive cleaning agents.
©

Service

½
WARNING!
repaired at the service centre or by
qualified specialist personnel using
original manufacturer parts only. This
will ensure that your device remains safe to use.
½
WARNING!
needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
©

Warranty

The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
Before you carry out any work
Have your device
If the plug or lead
GB 11