Slave Mode - Cameo LUXIS FC Bedienungsanleitung

EZ REMOTE CONTROL VIA CAMEO UNICON (optionally available)
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to
select the menu item EZ Remote and confirm with ENTER. Now set the desired device ID (Fixture
ID 1– 8) using UP and DOWN and confirm with ENTER.
Connect the spotlight and UNICON using a DMX cable, select DMX Control in the UNICON menu,
then EZ Remote, and enter the same unit ID. Now control the spotlight using RGB, GEL, CCT or
HSI. By assigning different unit IDs, up to eight spotlights (or spotlight groups) can be controlled
separately via UNICON. Alternatively, the control signals can be output to all eight IDs in parallel.

SLAVE MODE

Standard slave mode: Starting from the main display, press MENU to enter the main menu.
Now use UP and DOWN to select the menu item Slave, confirm with ENTER, select Slave Group
0 (Slave Group 0) and again confirm with ENTER. Connect the slave and the master units (same
model, same software version) using a DMX cable, and enable one of the standalone modes on
the master unit (Auto, Static, Colour Preset, Play Loop). The slave unit will now follow the master
unit.
20