Oled Display; Control Buttons - Cameo LUXIS FC Bedienungsanleitung

2 POWER OUT
TRUE1-compatible mains output socket. Facilitates power supply to other CAMEO lights. Ensure
that the total power consumption of all devices connected to the device does not exceed the given
ampere (A) value.
3 FUSE
Fuse holder for 5 x 20 mm fuses. IMPORTANT: Replace the fuse only with a fuse of the same type
and value. In the event of repeated fuse failure, please contact an authorised service centre.
4 DMX IN
Male 3-pin and 5-pin XLR sockets for connection of a DMX control device (e.g. DMX console).
Only use the ports alternatively.
5 DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal. Only use the ports
alternatively.
6 IDMX STICK
Connection for the optional iDMX stick for W-DMX™ connection (plug in the iDMX stick with the
antenna facing upwards). When the spotlight is controlled via an iDMX stick, the control signal is
transmitted via DMX OUT. The iDMX stick and DMX IN are only to be used alternatively.
7

OLED DISPLAY

The OLED display shows the currently activated mode (main display), the menu items in the menu
and the numerical value or operating mode in certain menu items. If there is no input for approx.
30 seconds, the display automatically returns to the main display. Note regarding the main
display in operating modes with external control: As soon as the control signal is interrupted, the
characters in the display begin to flash. When there is a control signal again, the flashing stops.
Briefly pressing UP when in the main display rotates the display by 180°.
8

CONTROL BUTTONS

MENU – Press MENU to access the main menu. Press again or repeatedly to return to the main
display. Pressing MENU without confirming a value or status change with ENTER restores the
previously confirmed value or status.
ENTER – Press ENTER to access the menu levels to make value changes and use ENTER to
access the submenus. Confirm value or status changes by pressing ENTER.
UP and DOWN – Select individual menu items in the main menu (DMX start address, DMX
operating mode etc.) and in the submenus. Change the status or a value in a menu item, such as
the DMX start address.
12