Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Device - Dometic SMP 439A Montage- Und Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
Installing the device
For installation and mounting you will need the following tools:
Pen for marking
Drill bit set
Drill
Screwdriver
To secure the device in place you will need:
machine bolts (M4 or M5) with washers and self-locking nuts or
self-tapping screws or wood screws.
Fasten the device as follows:
➤ Hold the device against the installation location and mark the fastening points.
➤ Fasten the device with one screw through each hole in the holders.
6.2

Connecting the device

Connecting the battery
Observe the following instructions when connecting the battery:
!
CAUTION!
Avoid coming into contact with the battery fluid.
Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.
Make sure the battery terminals are clean when connecting them.
Make sure the plug connector is fitted securely.
Select a connection cable with a sufficient cross-section (suitable for 25 A).
Use both the positive and both the negative connections to connect the battery.
Lay the cables in accordance with VDE 100 (Germany).
Use the following cable colours:
– Red: positive connection
– Black: negative connection
Do not reverse the polarity. Reversing the polarity of the connections will cause a
great spark and the internal fuses will melt.
14
SMP439A
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis