Kenwood FPM90 Bedienungsanleitungen Seite 9

before plugging in
Make sure your electricity supply is the same as the one
shown on the underside of your appliance.
WARNING: THIS APPLIANCE MUST BE EARTHED.
This appliance conforms to EC Regulation 1935/2004 on
materials and articles intended to come into contact with
food.
before using for the first time
1 Remove the plastic blade covers from the knife blade.
Take care the blades are very sharp. These covers
should be discarded as they are to protect the blade during
manufacture and transit only.
2 Wash the parts see 'care & cleaning'
key
processor
power unit
detachable drive shaft
bowl
lid
wide feed tube
pushers
safety interlocks
cord storage (at back)
power on light
auto button
speed/pulse control
weighing function (Type FPM91)
kg/lb button
display screen
on/zero button
weighing tray
thermoresist blender
filler cap
lid
goblet
sealing ring
blade unit
filler cap vents
A - standard attachments
knife blade
dough tool
dual whisk
folding tool
max capacity disc
4mm slicing disc
2mm slicing disc
4mm grating disc
2mm grating disc
attachment storage box
B - optional attachments
Not all the attachments listed below will be included with your
food processor model. Attachments are dependent upon the
model variant. For more information or to order additional
attachments refer to the "service and customer care" section.
extra fine grater disc (if supplied)
fine Julienne disc (if supplied)
decorative slicing disc (if supplied)
French fry disc (if supplied)
mini bowl and blade (if supplied)
compact chopper/grinder (if supplied)
citrus juicer (if supplied)
metal juicer extractor (if supplied)
to use your food processor
1 Fit the detachable drive shaft onto the power unit
down lightly to ensure the drive shaft is fully engaged.
2 Then fit the bowl to the power unit. Place the handle
towards the back on the right hand side and turn clockwise
until it locks.
3 Fit an attachment over the bowl drive shaft.
Always fit the bowl and attachment onto the processor
before adding ingredients.
4 Fit the lid - ensuring the top of the drive shaft/tool locates
into the centre of the lid.
5 Fit the pushers to the feed tube – turn the small pusher
clockwise to lock in position
The processor will not operate if the bowl, lid or
wide feed tube pusher are not fitted correctly
into the interlocks. Check that the feed tube and
bowl handle are situated to the right hand side.
6 Plug in. The Power On light will come on and flash until the
bowl and lid are fitted correctly. Select one of the following
options: -
Auto Button – the light will come on when the Auto Button is
pressed and the optimum speed for the attachment will be
automatically selected.
Speed Control – manually select the required speed (refer to
the recommended speed chart).
Pulse – use the pulse (P) for short bursts. The pulse will
operate for as long as the control is held in position.
7 At the end of processing turn the speed control to the 'O'
off position or if using the Auto press the button and the
light will go out.
The Power On light will flash if either the lid,
bowl or wide feed tube are not fitted.
The Power On and Auto lights will flash if the
Auto is selected but the interlocks are not
engaged.
The Auto Button will not operate if a speed is
selected on the speed control.
Always switch off and unplug before removing
the lid.
important
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
7
– push
.