Ferm JSM1018 Gebrauchsanweisung Seite 7

CE KONFORMITETSERKLÆRING (DK)
Vi erklærer herved, udelukkende på eget ansvar, at dette
opfylder følgende standarder eller standardiserede dokumenter:
EN55014-1, EN55014-2, EN60745-1, EN60745-2-11, EN60825-1,
EN61000-3-2, EN61000-3-3
i henhold til bestemmelserne i direktiverne:
98/37/EC, 73/23/EEC, 89/336/EEC, 2002/95/EC, 2002/96/EC
ab 01-04-2007
ZWOLLE NL
J.A. Bakker - van Ingen
CEO Ferm BV
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor
til enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
DK
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
114
FJS-750L
J. Lodewijk
Quality Manager Ferm Global
These can cause the saw blade to jam dangerously. Also watch out for this with waste
wood. This often requires less careful sawing, so there is a danger that you may not
be quite so careful about watching out for irregularities in the wood.
• Do not saw workpieces that are thicker than the length of the saw blade.
• Do not touch metal parts of the jigsaw when sawing in walls or floors in which there
could be electricity cables.
Hold the jigsaw tightly with both hands on the plastic grip so that you do not touch
parts that could become live if you accidentally saw through an electricity cable.
• When you have finished sawing, switch off the appliance first and wait until the saw
blade comes to a standstill before removing it from the workpiece.
• Do not use long extension cables.
• Keep the guard in place while the jigsaw is in use.
Turn the appliance off immediatey in the event of:
• A faulty mains plug, mains flex or flex damage;
• A faulty switch;
• Sparking in the carbon brushes or ring fire in the commutator;
• Smoke or smell from scorched insulation.
Safety tips for the laser beamer
• Never look into the light beam of the laser.
• Never point the light beam of the laser at humans or animals.
• Do not point the light beam of the laser at strongly reflecting material. Hazard from
reflected light.
• Only have repairs made to the laser beamer by qualified personnel / professional
repair specialists.
• Do not insert any hard objects into the laser optics.
• Clean the laser optics with a soft, dry brush.
Electrical safety
Always check that the mains voltage is the same as on the type plate of the
machine.
The machine is double insulated; therefore, no earth connection is required.
Replacement of powercords or plugs
Immediately dispose of old cords and plugs once they have been replaced. It is
dangerous to plug a loose power cord into a mains power socket.
Use of extension leads
Only ever use approved extension leads that are suitable for the power rating of the
machine. The minimum core thickness is 1.5 mm
always fully unroll the lead.
Ferm Ferm
2 . Whenever using a reel extension lead,
GB
07